Machine Design A pressure vessel is said to be a thick shell, if the ratio of wall thickness to its diameter is Less than 1/10 None of these Equal to 1/10 Greater than 1/10 Less than 1/10 None of these Equal to 1/10 Greater than 1/10 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using None of these Goodman relation Soderberg relation Gerber relation None of these Goodman relation Soderberg relation Gerber relation ANSWER DOWNLOAD EXAMIANS APP
Machine Design The value of Lewis form factor used in design of gears is Dependent on system of teeth All of these Dependent on number of teeth of a gear Independent of size of teeth Dependent on system of teeth All of these Dependent on number of teeth of a gear Independent of size of teeth ANSWER DOWNLOAD EXAMIANS APP
Machine Design For maximum power, the velocity of the belt will be None of these √(T/m) √(T/3m) √(T/2m) None of these √(T/m) √(T/3m) √(T/2m) ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to 1 d 1.25 d 1.5 d 1.75 d 1 d 1.25 d 1.5 d 1.75 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design For a shaft diameter of 200 mm, the number of bolts in a marine flange coupling should be 6 10 4 8 6 10 4 8 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS