Mass Transfer Rose oil is extracted from rose leaves using __________ distillation. High pressure Steam Extractive Low pressure High pressure Steam Extractive Low pressure ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer Pick out the wrong statement pertaining to leaching. Door classifier can be used for leaching of coarse solids Vegetable seeds can be leached in either of Bollman extractor, Rotocel or Kennedy extractor Fine solids can not be leached in a Pachuka tank Very high temperature is not needed for the leaching of sugar beet Door classifier can be used for leaching of coarse solids Vegetable seeds can be leached in either of Bollman extractor, Rotocel or Kennedy extractor Fine solids can not be leached in a Pachuka tank Very high temperature is not needed for the leaching of sugar beet ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer A 25 cm x 25 cm x 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m x 1m x 1cm flat sheet of the same material is to be dried from one side only.Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is 2500 1500 1000 2000 2500 1500 1000 2000 ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer Mass transfer co-efficient is directly proportional to DAB according to the __________ theory. Film None of these Surface-renewal Penetration Film None of these Surface-renewal Penetration ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer For absorbing a sparingly soluble gas in a liquid Mass transfer co-efficient must be kept constant Gas side mass transfer co-efficient should be increased Liquid side mass transfer co-efficient should be decreased Liquid side mass transfer co-efficient should be increased Mass transfer co-efficient must be kept constant Gas side mass transfer co-efficient should be increased Liquid side mass transfer co-efficient should be decreased Liquid side mass transfer co-efficient should be increased ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of __________ microns (1 mm = 1000 microns). > 500 43835 22190 200-300 > 500 43835 22190 200-300 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS