Machine Design I.S. specifies following total number of grades of tolerances 20 16 18 22 20 16 18 22 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of pulleys for V-belt is 420 to 450 More than 400 300 to 320 340 to 360 420 to 450 More than 400 300 to 320 340 to 360 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which of the following statement is correct for gears? The pitch circle diameter is equal to the product of module and number of teeth The pitch circle is always greater than the base circle The addendum is less than dedendum All of these The pitch circle diameter is equal to the product of module and number of teeth The pitch circle is always greater than the base circle The addendum is less than dedendum All of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design A woodruff key is A tapered key with head at one end Capable of tilting in a recess milled out in the shaft All of these Fitted in pairs at right angles A tapered key with head at one end Capable of tilting in a recess milled out in the shaft All of these Fitted in pairs at right angles ANSWER DOWNLOAD EXAMIANS APP
Machine Design When two non-intersecting and non-coplanar shafts are connected by gears, the arrangement is known as Bevel gearing Helical gearing Spiral gearing Spur gearing Bevel gearing Helical gearing Spiral gearing Spur gearing ANSWER DOWNLOAD EXAMIANS APP
Machine Design The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is 7.5 kN 22.5 kN 10.6 kN 15 kN 7.5 kN 22.5 kN 10.6 kN 15 kN ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS