Machine Design A woodruff key is Fitted in pairs at right angles All of these Capable of tilting in a recess milled out in the shaft A tapered key with head at one end Fitted in pairs at right angles All of these Capable of tilting in a recess milled out in the shaft A tapered key with head at one end ANSWER DOWNLOAD EXAMIANS APP
Machine Design The suitable material for belt in agricultural machinery is Cotton duck Rubber Leather Balata gum Cotton duck Rubber Leather Balata gum ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) P1 + P2 [⅟₂ × (P1 + P2)] + Pc ⅟₂ × (P1 + P2) P1 - P2 P1 + P2 [⅟₂ × (P1 + P2)] + Pc ⅟₂ × (P1 + P2) P1 - P2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 3.5 2.5 3.0 2.8 3.5 2.5 3.0 2.8 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The endurance limit of a material with finished surface in comparison to rough surface is More or less depending on quantum of load Same More Less More or less depending on quantum of load Same More Less ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a steam engine, the valve rod is connected to an eccentric rod by means of Universal joint Knuckle joint Flange coupling Cotter joint Universal joint Knuckle joint Flange coupling Cotter joint ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS