The wattage rating for a ceiling fan motor is in the range of 50 to 150 W. if the ceiling Fans size ranges from 36 inches to 56 inches then the total wattage use is 55 to 100 watts.. A 48-inch ceiling fan will use 75 watts.
The permeance of the magnetic circuit is defined as the reciprocal of the reluctance. Permeance = 1/Reluctance It is defined as the property of the magnetic circuit due to which it allows the flow of the magnetic flux through it. Permeance is analogous to conductance in an electric circuit.
The commutator is a feature of d.c.motors. But a.c. motors having wound rotor with brushes and commutator arrangements, are called commutator motors that work on single-phase a.c. supply. The commutator arrangement present in these motors is similar to the armature of a d.c. motor.E.g. of single-phase commutator type induction motor is Repulsion Motor Repulsion-Induction Motor AC Series Motor Universal Motor
Average speed:- The distance covered between two stops divided by the actual time of the run is known as average speed. Average speed = (Distance between stops)/(Actual time of run) Schedule speed:- It is defined as the ratio of distance covered between two stops and the total time of run including the time of the stop. Schedule speed = (Distance between stops) /(Actual time of run + Stop time) This shows that schedule speed is always smaller than the average speed. The difference is large in the case of urban and suburban services and is negligibly small in the case of main-line service.
The transformers which are particularly designed to provide electrical isolation between primary and secondary circuits, without a change in voltage and current level are called isolation transformers. The turns ratio of such isolation transformers is 1:1 i.e N1 and N2. Hence, isolation transformers are also called 1:1 transformers. The isolation transformer greatly reduces any voltage spikes that originate on the supply side before they are transferred to the load side. Some isolation transformers are built with a turns ratio of 1:1. A transformer of this type has the same input and output voltages and is used for the purpose of isolation only. The main function of the isolation transformer is to reduce the voltage spike before it reaches the load.
While estimating the overhead lines, the first and last pole is always earth connected and after every 3rd electrical pole, the fourth pole is earthed. Therefore, the approximate number of required ground set = 4
EXAMIANS