Engineering Drawing The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features. Quick Dimension Continue Baseline Linear Quick Dimension Continue Baseline Linear ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Which of the following is one of the basic types of welded joints: Angle joint Groove joint Rear joint T-joint Angle joint Groove joint Rear joint T-joint ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This type of solid has two bases that are parallel equal polygons: Pyramid Prism Cone Torus Pyramid Prism Cone Torus ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension: Allowance Difference Specification Tolerance Allowance Difference Specification Tolerance ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection: Secondary Successive Revolved Primary Secondary Successive Revolved Primary ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________. Type 3 back slash and enter Type @3 Type 3 forward slash and enter Type 3 and try to use the Dynamic Input readout to find the end point Type 3 back slash and enter Type @3 Type 3 forward slash and enter Type 3 and try to use the Dynamic Input readout to find the end point ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS