Machine Design The taper on key is given on Top side only Any side On both sides Bottom side only Top side only Any side On both sides Bottom side only ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two rigid plates are clamped by means of bolt and nut with an initial force F. After tightening, a separating force P (P < F) is applied to the lower plate, which in turn acts on the nut. The tension in the both after this is F.P F + P F P F.P F + P F P ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of belt tensions (p1/p2) considering centrifugal force in flat belt is given byWhere m = mass of belt per meter (kg/m)v = belt velocity (m/s)f = coefficient of frictiona = angle of wrap (radians) (P1 - mv²)/ (P2 - mv²) = eᶠα P1 / P2 = e–ᶠα (P1 - mv²)/ (P2 - mv²) = e–ᶠα P1 / P2 = eᶠα (P1 - mv²)/ (P2 - mv²) = eᶠα P1 / P2 = e–ᶠα (P1 - mv²)/ (P2 - mv²) = e–ᶠα P1 / P2 = eᶠα ANSWER DOWNLOAD EXAMIANS APP
Machine Design In skew bevel gearing, the axes of shafts are Non-intersecting and non-parallel and the teeth are straight Non-intersecting and nonparallel and the teeth are curved Intersecting and the teeth are curved None of these Non-intersecting and non-parallel and the teeth are straight Non-intersecting and nonparallel and the teeth are curved Intersecting and the teeth are curved None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design The bearing characteristic number in a hydrodynamic bearing depends upon Length, width and speed Viscosity, speed and bearing pressure Viscosity, speed and load Length, width and load Length, width and speed Viscosity, speed and bearing pressure Viscosity, speed and load Length, width and load ANSWER DOWNLOAD EXAMIANS APP
Machine Design Set screws are Similar to stud Used to prevent relative motion between parts Similar to small size tap bolts except that a greater variety of shapes of heads are available Slotted for a screw driver and generally used with a nut Similar to stud Used to prevent relative motion between parts Similar to small size tap bolts except that a greater variety of shapes of heads are available Slotted for a screw driver and generally used with a nut ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS