Process Equipment and Plant Design Vertical vessels are not supported by Saddles Brackets Columns Skirts Saddles Brackets Columns Skirts ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Weep holes provided in the plates of a distillation column Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation All of these Facilitate draining out liquid from a tray when the unit is not in operation Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation All of these Facilitate draining out liquid from a tray when the unit is not in operation ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the Liquid/vapor loading across the column remains constant Sensible heat differences are small, because the temperature changes from tray to tray is small All of these Trouton's rule is applicable Liquid/vapor loading across the column remains constant Sensible heat differences are small, because the temperature changes from tray to tray is small All of these Trouton's rule is applicable ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is Shear Deformation Elongation Bending Shear Deformation Elongation Bending ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of (1.2)5/3 (1.2)2/3 (1.2)3/5 (1.2)3/2 (1.2)5/3 (1.2)2/3 (1.2)3/5 (1.2)3/2 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS