Digital Electronics In digital systems, 1 byte is equal to ________ bit(s). 2 4 8 1 2 4 8 1 ANSWER DOWNLOAD EXAMIANS APP
Digital Electronics A computer has a word length of 8 bits (including sign). It is required to determine the range of integers that can be stored in the computer. If 1’s complement is used to represent the numbers, then the range will be -256 to 255 -127 to 127 -128 to 127 -256 to 256 -256 to 255 -127 to 127 -128 to 127 -256 to 256 ANSWER DOWNLOAD EXAMIANS APP
Digital Electronics The AND-OR realization of a combinational circuit requires three 3-input AND gates and one 3-input OR gate. This circuit can be designed using three 3-input OR gates and one 3-input AND gate None of these four input NAND gates only three 3-input NAND gates and one 3-input NOR gate three 3-input OR gates and one 3-input AND gate None of these four input NAND gates only three 3-input NAND gates and one 3-input NOR gate ANSWER DOWNLOAD EXAMIANS APP
Digital Electronics The simplified block diagram of a 10-bit A/D converter of dual slope integrator type is shown in figure. The 10-bit counter at the output is clocked by a 1 Mhz clock. Assuming negligible timing overhead for the control logic, the maximum frequency of the analog signal that can be converted using this A/D converted is approximately . 1 KHz. 250 Hz. 2 KHz. 500 Hz. 1 KHz. 250 Hz. 2 KHz. 500 Hz. ANSWER DOWNLOAD EXAMIANS APP
Digital Electronics The binary number designations of the rows and columns of the K-map are in binary code BCD code XS-3 code Gray code binary code BCD code XS-3 code Gray code ANSWER DOWNLOAD EXAMIANS APP
Digital Electronics What is the difference between xor gate and exor gate. xor gives one output while exor gives two xor gives two outputs while exor gives one both are same xor and exor are complement of each other xor gives one output while exor gives two xor gives two outputs while exor gives one both are same xor and exor are complement of each other ANSWER DOWNLOAD EXAMIANS APP