Electrical Machines In a synchronous generator, if mechanical input is increased with constant excitation, the load angle will either increase or decrease decrease increase None of these either increase or decrease decrease increase None of these ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines A 5 KVA transformer has a turns ratio of N1/N2 = 10. The impedance of primary winding is 3+j5 ohms while that of secondary winding is 0.5+j0.8 ohms. The impedance of transformer when referred to primary will be 53+j85 ohms 3.05+j5.08 ohms 3.5+j5.8 ohms 8+j13 ohms 53+j85 ohms 3.05+j5.08 ohms 3.5+j5.8 ohms 8+j13 ohms ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Which of the following is not a part of transformer? Tap changer. Commutator. Conservator tank. Radiator. Tap changer. Commutator. Conservator tank. Radiator. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines A 4 pole dc motor with armature winding resistance of 0.6 ohm receives a supply of 230 Volt. If the back emf produced during running condition is equal to 210 volt. Calculate the current flowing through the armature at this point. 43 Amp. 29 Amp. 44.47 Amp. 33.33 Amp. 43 Amp. 29 Amp. 44.47 Amp. 33.33 Amp. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Reactive power generated or delivered significantly depends on excitation. load angle. frequency. both 1 and 2. excitation. load angle. frequency. both 1 and 2. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines A transformer core is made up of a silicon steel laminations which has maximum flux density 1 Tesla. If it was cold rolled grain oriented its flux density increases to 1.6 Tesla. What is the saving in core size or area due to cold rolled grain oriented process? 68% 60% 40% 38% 68% 60% 40% 38% ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS