Manufacturing And Production Technology Green sand mould indicates that Polymeric mould has been cured Mould contains moisture Mould has been totally dried Mould is green in colour Polymeric mould has been cured Mould contains moisture Mould has been totally dried Mould is green in colour ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology It is desired to perform the operations like drilling, reaming, counter-boring etc. on a work piece. Which of the following machine will be used? Radial drilling machine Sensitive drilling machine Gang drilling machine Multiple spindle drilling machine Radial drilling machine Sensitive drilling machine Gang drilling machine Multiple spindle drilling machine ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A grinding wheel is said to be of _________ if it holds the abrasive grains more securely. None of the listed here Soft grade Hard grade Medium grade None of the listed here Soft grade Hard grade Medium grade ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is Feed rate, depth of cut, cutting speed Cutting speed, feed rate, depth of cut Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate Feed rate, depth of cut, cutting speed Cutting speed, feed rate, depth of cut Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the maximum chip thickness May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 36.56 26.56 30.56 20.56 36.56 26.56 30.56 20.56 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS