Manufacturing And Production Technology Gear finishing operation is called Shaping Milling Burnishing Hobbing Shaping Milling Burnishing Hobbing ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is wrong about ultrasonic machining? It cuts materials at very slow speeds It produces good surface finish It removes large amount of material It is best suited for machining hard and brittle materials. It cuts materials at very slow speeds It produces good surface finish It removes large amount of material It is best suited for machining hard and brittle materials. ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become Sixteen times Eight times Half Two times Sixteen times Eight times Half Two times ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as Back rake angle End relief angle Side relief angle Side rake angle Back rake angle End relief angle Side relief angle Side rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant) V/Tn = C VnT = C VTn = C Vn/T = C V/Tn = C VnT = C VTn = C Vn/T = C ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Doubled Halved Unchanged Quadrupled Doubled Halved Unchanged Quadrupled ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS