Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Doubled Unchanged Halved Quadrupled Doubled Unchanged Halved Quadrupled ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Down milling is also called End milling Climb milling Face milling Conventional milling End milling Climb milling Face milling Conventional milling ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Cast iron during machining produces Continuous chips with built-up edge None of these Discontinuous chips Continuous chips Continuous chips with built-up edge None of these Discontinuous chips Continuous chips ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In drilling brass, a drill with Zero helix angle is used Low helix angle is used Any helix angle can be used High helix angle is used Zero helix angle is used Low helix angle is used Any helix angle can be used High helix angle is used ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The percentage of carbon in gray cast iron is in the range of 1.25 to 1.75 percent 0.25 to 0.75 percent 8 to 10 percent 3 to 4 percent 1.25 to 1.75 percent 0.25 to 0.75 percent 8 to 10 percent 3 to 4 percent ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The actual feed in centerless grinders is given by (where d = Dia. of regulating wheel, n = Revolutions per minute, and α = Angle of inclination of wheel) πd πdn sinα πdn πdn cosα πd πdn sinα πdn πdn cosα ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS