Manufacturing And Production Technology For turning small taper on long workpiece, the suitable method is By a form tool By swiveling the compound rest By a taper turning attachment By setting over the tail stock By a form tool By swiveling the compound rest By a taper turning attachment By setting over the tail stock ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If the flame of the welding torch is directed towards the progress of welding, then what will you call the welding technique? Forehand welding Pulsed spray welding Flux cored ARC welding Electro slag welding Forehand welding Pulsed spray welding Flux cored ARC welding Electro slag welding ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In electro discharge machining, tool is made of Copper tungsten alloy All of these Brass Copper Copper tungsten alloy All of these Brass Copper ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Chip breakers are used to Remove chips from bed To minimize heat generation Break the chips into short segments Increase tool life Remove chips from bed To minimize heat generation Break the chips into short segments Increase tool life ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Larger end cutting edge angle _________ tool life. None of these Does not effect Decreases Increases None of these Does not effect Decreases Increases ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is incorrect with reference of lathe cutting tools? The flank of the tool is the surface or surfaces below and adjacent to the cutting edges The nose is the corner, arc or chamfer joining the side cutting and the end cutting edges The base is that surface of the shank which bears against the support and takes tangent pressure of the cut The heel is that part of the tool which is shaped to produce the cutting edges and face The flank of the tool is the surface or surfaces below and adjacent to the cutting edges The nose is the corner, arc or chamfer joining the side cutting and the end cutting edges The base is that surface of the shank which bears against the support and takes tangent pressure of the cut The heel is that part of the tool which is shaped to produce the cutting edges and face ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS