Machine Design A connecting rod subjected to an axial load may buckle with X-axis or Y-axis as neutral axis Y-axis as neutral axis X-axis as neutral axis Z-axis X-axis or Y-axis as neutral axis Y-axis as neutral axis X-axis as neutral axis Z-axis ANSWER DOWNLOAD EXAMIANS APP
Machine Design In thrust bearings, the load acts Perpendicular to the axis of rotation Along the axis of rotation In any direction Parallel to the axis of rotation Perpendicular to the axis of rotation Along the axis of rotation In any direction Parallel to the axis of rotation ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for ordinary cut gears operating at velocities up to 12.5 m/s is equal to 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) 6/(6 + v) 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) 6/(6 + v) ANSWER DOWNLOAD EXAMIANS APP
Machine Design The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is 0.1 micron 0.01 micron 1 micron 10 microns 0.1 micron 0.01 micron 1 micron 10 microns ANSWER DOWNLOAD EXAMIANS APP
Machine Design Transverse fillet welded joints are designed for Shear strength Compressive strength Bending strength Tensile strength Shear strength Compressive strength Bending strength Tensile strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design The width of the pulley should be __________ width of the belt. Less than Greater than Equal to None of these Less than Greater than Equal to None of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS