You have been contracted to install a windows NT network in an office that is located in a strip mall. The office is located next to the power plant of the building, so a UPS (uninterruptible power supply) has already been installed. What type of cable should you use for the network cabling? Choose the best answer.

Computer Networking
You have been contracted to install a windows NT network in an office that is located in a strip mall. The office is located next to the power plant of the building, so a UPS (uninterruptible power supply) has already been installed. What type of cable should you use for the network cabling? Choose the best answer.

Fiber-optic

PSTN

UTP

TI

STP

Fiber-optic

PSTN

UTP

TI

STP

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Using the illustration from the previous question, what would be the IP address of SO if you were using the first subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. Again, the zero subnet should not be considered valid for this question.

192.168.10.24

192.168.10.127

192.168.10.62

192.168.10.30

192.168.10.24

192.168.10.127

192.168.10.62

192.168.10.30

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?

The switch port the host is connected to is not configured to the correct VLAN membership.

The host has an invalid MAC address.

The VTP configuration on the switch is not updated for the new host.

The router is not configured for the new host.

The switch port the host is connected to is not configured to the correct VLAN membership.

The host has an invalid MAC address.

The VTP configuration on the switch is not updated for the new host.

The router is not configured for the new host.

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You are working with a class C network. You are required to configure it for five subnets, each of which will support 25 nodes. What subnet should you use?

255.255.255.224

255.255.255.240

255.255.255.252

255.255.255.248

255.255.255.0

255.255.255.224

255.255.255.240

255.255.255.252

255.255.255.248

255.255.255.0

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
What PPP protocol provides dynamic addressing, authentication, and multilink?

LCP

NCP

HDLC

X.25

LCP

NCP

HDLC

X.25

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Which command is used to determine if an IP access list is enabled on a particular interface?

show interface

show ip interface

show interface access-lists

show access-lists

show interface

show ip interface

show interface access-lists

show access-lists

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking

Computer Networking You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?

Computer Networking You are working with a class C network. You are required to configure it for five subnets, each of which will support 25 nodes. What subnet should you use?

Computer Networking What PPP protocol provides dynamic addressing, authentication, and multilink?

Computer Networking Which command is used to determine if an IP access list is enabled on a particular interface?

Computer Networking
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?

Computer Networking
You are working with a class C network. You are required to configure it for five subnets, each of which will support 25 nodes. What subnet should you use?

Computer Networking
What PPP protocol provides dynamic addressing, authentication, and multilink?

Computer Networking
Which command is used to determine if an IP access list is enabled on a particular interface?