Power Systems Which type of connection is employed for current transformers for the protection of star- delta connected 3-phase transformer? star-star delta-delta star-delta delta-star star-star delta-delta star-delta delta-star ANSWER DOWNLOAD EXAMIANS APP
Power Systems A load centre is at an equidistant from the two thermal generating stations G1 and G2. The fuel cost characteristics of the generating stations are given by F1 = a + bP1 + cP²1 F2 = a + b P2 + 2cP²2 Where P1 and P2 are the generation in MW of G1 and G2, respectively. For most economic generation to meet 300 MW of load, P1 and P2 respectively, are 150, 150 100, 200 175, 125 200, 100 150, 150 100, 200 175, 125 200, 100 ANSWER DOWNLOAD EXAMIANS APP
Power Systems An unloaded generator with a pre-fault voltage 1 pu has the following sequence impedance: Z0 = j 0.15 pu, Z1 = Z2 = j 0.25 pu The neutral is grounded with a reactance of 0.05 pu. The fault current in pu for single line to ground fault is 4.28 pu 2.5 pu 7.25 pu 3.75 pu 4.28 pu 2.5 pu 7.25 pu 3.75 pu ANSWER DOWNLOAD EXAMIANS APP
Power Systems Stock bridge dampers are used to increase the sag reduce the tension reduce the vibrations at the point of support All of these increase the sag reduce the tension reduce the vibrations at the point of support All of these ANSWER DOWNLOAD EXAMIANS APP
Power Systems A lossless power system has to serve a load of 250 MW. There are two generators(G1 and G2) in the system with cost curves C1 and C2 respectively defined as follows: C1 = PG1+0.055P²G1 C2 = 3 PG2 + 0.03 P²G2 Where PG1 and PG2 are the MW injections from generators G1 and G2 respectively. Thus, the minimum cost dispatch will be PG1 = 0 MW and PG2 = 250 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 100 MW and PG2 = 150 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 100 MW and PG2 = 150 MW ANSWER DOWNLOAD EXAMIANS APP
Power Systems In an induction relay for a particular current setting the operating time 4 sec. When the time multiplier setting is 0.8 if the time multiplier setting is rest to 1 the operating time is un changed. 5. 1. 10. un changed. 5. 1. 10. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS