Computer Networking Which of the following is true regarding VLANs? You should not have more than 10 switches in the same VTP domain. You must have at least two VLANs defined in every Cisco switched network. VTP is used to send VLAN information to switches in a configured VTP domain. All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches. You should not have more than 10 switches in the same VTP domain. You must have at least two VLANs defined in every Cisco switched network. VTP is used to send VLAN information to switches in a configured VTP domain. All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?1. show version2. show protocols3. show interfaces4. show controllers5. show ip interface 3 and 4 only 2, 3 and 5 None of these 1, 2 and 4 3 and 4 only 2, 3 and 5 None of these 1, 2 and 4 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The synchronous modems are more costly than the asynchronous modems because they produce large volume of data they contain clock recovery circuits they operate with a larger bandwidth None of these they transmit the data with stop and start bits. they produce large volume of data they contain clock recovery circuits they operate with a larger bandwidth None of these they transmit the data with stop and start bits. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Acknowledgments, sequencing, and flow control are characteristics of which OSI layer? Layer 2 Layer 7 Layer 4 Layer 3 Layer 2 Layer 7 Layer 4 Layer 3 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which IP address class has few hosts per network? None of these C D B A None of these C D B A ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To enable EIGRP, which of the following would you use?1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.02. Router1(config-if)# ipv6 router rip 13. Router1(config)# ipv6 router eigrp 104. Router1(config-rtr)# no shutdown5. Router1(config-if)# ipv6 eigrp 10 3, 4 and 5 5 only 1, 3 and 5 1 and 3 3, 4 and 5 5 only 1, 3 and 5 1 and 3 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS