Machine Design When two non-parallel or intersecting but coplanar shafts are connected by gears, the arrangement is known as, Helical gearing Worm gearing Bevel gearing None of these Helical gearing Worm gearing Bevel gearing None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design The static tooth load should be __________ the dynamic load. Equal to Less than Greater than None of these Equal to Less than Greater than None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (WD/ πd3) × K (8WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (WD/ πd3) × K (8WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a partial journal bearing, the angle of contact of the bearing with the journal is 360° 180° 120° 270° 360° 180° 120° 270° ANSWER DOWNLOAD EXAMIANS APP
Machine Design A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, the junction radius is 60 mm and the junction pressure is 1.1 N/mm². The maximum hoop stress developed in the inner cylinder is 3.6 N/mm² compression 7.2 N/mm² tension 7.2 N/mm² compression 3.6 N/mm² tension 3.6 N/mm² compression 7.2 N/mm² tension 7.2 N/mm² compression 3.6 N/mm² tension ANSWER DOWNLOAD EXAMIANS APP
Machine Design In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called Normal pitch Diametral pitch Axial pitch Module Normal pitch Diametral pitch Axial pitch Module ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS