Workshop Technology When a hole or cavity to be cored is not in line with the parting surface, then a ________ is used. Vertical core Drop core Balanced core Horizontal core Vertical core Drop core Balanced core Horizontal core ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The maximum flame temperature occurs At the outer cone At the inner cone Between the outer and inner cone At the torch tip At the outer cone At the inner cone Between the outer and inner cone At the torch tip ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A progressive limit gauge has None of the listed here 'Go' member at one end and 'Not go' member at the other end Separate 'Go' and 'Not go' members 'Go' and 'Not go' member on the same side of the gauge None of the listed here 'Go' member at one end and 'Not go' member at the other end Separate 'Go' and 'Not go' members 'Go' and 'Not go' member on the same side of the gauge ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be 20 mm/m 16 mm/m 26 mm/m 10 mm/m 20 mm/m 16 mm/m 26 mm/m 10 mm/m ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The width of slot cut by a hacksaw blade is ___ the width of the blade. Equal to Greater than None of the listed here Less than Equal to Greater than None of the listed here Less than ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The cold working of metals is carried out At the recrystallisation temperature Above the recrystallisation temperature Below the recrystallisation temperature At any temperature At the recrystallisation temperature Above the recrystallisation temperature Below the recrystallisation temperature At any temperature ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS