Measurement and Instrumentation When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is All right None of these Faulty Short-circuited All right None of these Faulty Short-circuited ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read + 597 W. + 795 W. - 795 W. - 597 W. + 597 W. + 795 W. - 795 W. - 597 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The EMF of Weston standard cell is measured using Moving-coil meter Digital Volt meter Moving- iron meter Potentiometer Moving-coil meter Digital Volt meter Moving- iron meter Potentiometer ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Relative permittivity can be measured by _______ bridge Hays. Schering. Wheatstones. Desautys. Hays. Schering. Wheatstones. Desautys. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The resistance offered to the passage of an in-varying current by a column of mercury at the temperature of melting ice of mass 14.4521 gms of uniform cross-sectional area and length 106.3cm is One ohm according to working standards One international ohm One ohm according to SI units Standard ohm One ohm according to working standards One international ohm One ohm according to SI units Standard ohm ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Most accurate measurement of unknown resistance will be by Potentiometer Ohmmeter Wheatstone bridge Voltmeter and ammeter Potentiometer Ohmmeter Wheatstone bridge Voltmeter and ammeter ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS