Manufacturing And Production Technology What is the type of welding defect is caused due to stresses on heating and cooling called? Incomplete fusion Slag Entrapment (Inclusions) Shrinkage void Incomplete penetration Incomplete fusion Slag Entrapment (Inclusions) Shrinkage void Incomplete penetration ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 20.56 36.56 26.56 30.56 20.56 36.56 26.56 30.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side relief angle of a single point tool is the angle By which the face of the tool is inclined sideways By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined sideways By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tail stock set over method of taper turning is preferred for Long slender tapers Steep tapers Internal tapers Small tapers Long slender tapers Steep tapers Internal tapers Small tapers ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Green sand mould indicates that Mould is green in colour Mould contains moisture Mould has been totally dried Polymeric mould has been cured Mould is green in colour Mould contains moisture Mould has been totally dried Polymeric mould has been cured ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Gear burnishing is a process for Undercut gears Surface finishing Cycloidal gears Removing residual stresses from teeth roots Undercut gears Surface finishing Cycloidal gears Removing residual stresses from teeth roots ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS