Manufacturing And Production Technology What is the name of the device used in arc welding circuits for the purpose of modifying the rate of current change when the weld road is varied rapidly? Kerf Inductor Cone Reactor Kerf Inductor Cone Reactor ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the type of shielding gas for GTAW (Gas Tungsten Arc Welding) used for carbon steels only called? Argon Helium Argon CO₂ Helium Argon H₂ Argon Helium Argon CO₂ Helium Argon H₂ ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Calculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. 600 welds/min, 1500 mm/min 22 welds/min, 55 mm/min 3000 welds/min, 75 mm/min 500 welds/min, 1250 mm/min 600 welds/min, 1500 mm/min 22 welds/min, 55 mm/min 3000 welds/min, 75 mm/min 500 welds/min, 1250 mm/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the type of welding defect caused due to poor deposition of weld rod is called? Crack Porosity Under fill Undercut Crack Porosity Under fill Undercut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The effect of setting a boring tool above center height leads to Decrease in both effective rake angle and effective clearance angle Increase in both effective rake angle and effective clearance angle Increase in the effective rake angle and a decrease in the effective clearance angle Decrease in the effective rake angle and an increase in the effective clearance angle Decrease in both effective rake angle and effective clearance angle Increase in both effective rake angle and effective clearance angle Increase in the effective rake angle and a decrease in the effective clearance angle Decrease in the effective rake angle and an increase in the effective clearance angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is 100 mm 20 mm 0.2 mm 10 mm 100 mm 20 mm 0.2 mm 10 mm ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS