Microwave Communication What allow microwave to pass in only one direction? Ferrite emitter RF emitter Varactor-triac Capacitor Ferrite emitter RF emitter Varactor-triac Capacitor ANSWER DOWNLOAD EXAMIANS APP
Microwave Communication Which of the following permits a microwave signal to travel in one direction with virtually no loss, but severely attenuates any signal attempting to travel in the reverse direction? Tunnel diode Circulator Wave trap Isolator Tunnel diode Circulator Wave trap Isolator ANSWER DOWNLOAD EXAMIANS APP
Microwave Communication The aquadag coating on the inside of PPI tube is used As a second anode and to prevent the build-up of secondary field All of these To focus the beam of primary electrons To shield the electron beam from unidirectional magnetic As a second anode and to prevent the build-up of secondary field All of these To focus the beam of primary electrons To shield the electron beam from unidirectional magnetic ANSWER DOWNLOAD EXAMIANS APP
Microwave Communication To achieve good bearing resolution when using a pulsed-radar set, an important requirement is A narrow, antenna-beam width in the vertical plane A narrow, antenna-beam width in the horizontal plane A high duty cycle A low repetition rate A narrow, antenna-beam width in the vertical plane A narrow, antenna-beam width in the horizontal plane A high duty cycle A low repetition rate ANSWER DOWNLOAD EXAMIANS APP
Microwave Communication A reflex klystron is oscillating at the frequency of its resonant cavity. If the reflector voltage is made slightly less negative, the Oscillation will cease Output power would increase Bunching would occur earlier in time The frequency will decrease Oscillation will cease Output power would increase Bunching would occur earlier in time The frequency will decrease ANSWER DOWNLOAD EXAMIANS APP
Microwave Communication Oscillators of a klystron tube are maintained By circulating bunches of electrons within the cavities. By plate-to-cathode feedback By feedback between the accelerating grid and the repeller By bunches of electrons passing the cavity grids By circulating bunches of electrons within the cavities. By plate-to-cathode feedback By feedback between the accelerating grid and the repeller By bunches of electrons passing the cavity grids ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS