Computer Networking To enable RIPng, which of the following would you use? Router1(config)# ipv6 router eigrp 10 Router1(config-if)# ipv6 router rip 1 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config)# ipv6 router eigrp 10 Router1(config-if)# ipv6 router rip 1 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The synchronous modems are more costly than the asynchronous modems because they contain clock recovery circuits they transmit the data with stop and start bits. None of these they operate with a larger bandwidth they produce large volume of data they contain clock recovery circuits they transmit the data with stop and start bits. None of these they operate with a larger bandwidth they produce large volume of data ANSWER DOWNLOAD EXAMIANS APP
Computer Networking How much power (roughly) a light-emitting diode can couple into an optical fiber? 440 microwatts None of these 10 milliwatts 100 microwatts 100 picowatts 440 microwatts None of these 10 milliwatts 100 microwatts 100 picowatts ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following conditions is used to transmit two packets over a medium at the same time? Asynchronous None of these Collision Synchronous Contention Asynchronous None of these Collision Synchronous Contention ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which three statements are true about the operation of a full-duplex Ethernet network?1. There are no collisions in full-duplex mode.2. A dedicated switch port is required for each full-duplex node.3. Ethernet hub ports are preconfigured for full-duplex mode.4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.5. The host network card and the switch port must be capable of operating in full-duplex mode. 2, 3 and 4 5 only 1, 2, and 5 2 and 4 2, 3 and 4 5 only 1, 2, and 5 2 and 4 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What does a switch do when a frame is received on an interface and the destination hardware address is unknown or not in the filter table? Forwards the switch to the first available link Sends back a message to the originating station asking for a name resolution Drops the frame Floods the network with the frame looking for the device Forwards the switch to the first available link Sends back a message to the originating station asking for a name resolution Drops the frame Floods the network with the frame looking for the device ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS