Machine Design The stress which vary from a minimum value to a maximum value of the same nature (i.e. tensile or compressive) is called Fluctuating stress Yield stress Repeated stress Alternating stress Fluctuating stress Yield stress Repeated stress Alternating stress ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for precision metallic gears cut with high accuracy and operating at velocities up to 20 m/s is equal to 6/ (6 + v) 4.5/ (4.5 + v) 3/ (3 + v) 0.75/ (0.75 + √v) 6/ (6 + v) 4.5/ (4.5 + v) 3/ (3 + v) 0.75/ (0.75 + √v) ANSWER DOWNLOAD EXAMIANS APP
Machine Design The included angle in unified of American National threads is 60° 29° 55° 47° 60° 29° 55° 47° ANSWER DOWNLOAD EXAMIANS APP
Machine Design Stress concentration is caused due to Pitting at points or areas at which loads on a member are applied All of these Variation in properties of material from point to point in a member Abrupt change of section Pitting at points or areas at which loads on a member are applied All of these Variation in properties of material from point to point in a member Abrupt change of section ANSWER DOWNLOAD EXAMIANS APP
Machine Design A sliding bearing which operates without any lubricant present, is called Boundary lubricated bearing Zero film bearing Hydrodynamic lubricated bearing Hydrostatic lubricated bearing Boundary lubricated bearing Zero film bearing Hydrodynamic lubricated bearing Hydrostatic lubricated bearing ANSWER DOWNLOAD EXAMIANS APP
Machine Design The draw of cotter should not be more than 12 mm 8 mm 6 mm 3 mm 12 mm 8 mm 6 mm 3 mm ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS