Manufacturing And Production Technology The process of improving the cutting action of the grinding wheel is called Clearing Facing Dressing Truing Clearing Facing Dressing Truing ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a height of 25 mm. The percentage change in diameter is 2.07 20.7 41.4 2.07 20.7 41.4 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A right hand tool on a lathe cuts most efficiently when it travels From left to right end of the lathe bed Across the bed From right to left end of the lathe bed With the help of a compound slide From left to right end of the lathe bed Across the bed From right to left end of the lathe bed With the help of a compound slide ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In American Standard Association (ASA) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be 10° 6° 8° 5° 10° 6° 8° 5° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The lip angle of a single point tool is usually 20° to 40° 60° to 80° None of these 40° to 60° 20° to 40° 60° to 80° None of these 40° to 60° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The hole to be drilled for tapping is _________ the outside diameter of the thread on the tap. Equal to None of the listed here Greater than Smaller than Equal to None of the listed here Greater than Smaller than ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS