Machine Design The maximum bending stress in a curved beam having symmetrical section always occur at the Outside fiber Neutral axis Centroidal axis Inside fiber Outside fiber Neutral axis Centroidal axis Inside fiber ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) [⅟₂ × (P1 + P2)] + Pc P1 - P2 ⅟₂ × (P1 + P2) P1 + P2 [⅟₂ × (P1 + P2)] + Pc P1 - P2 ⅟₂ × (P1 + P2) P1 + P2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Deep groove ball bearings are used for Small angular displacement of shafts Combined thrust and radial loads at high speed Heavy thrust load only Radial load at high speed Small angular displacement of shafts Combined thrust and radial loads at high speed Heavy thrust load only Radial load at high speed ANSWER DOWNLOAD EXAMIANS APP
Machine Design Surface endurance limit of gear material is dependent upon its Yield strength Brinell hardness number Toughness Elastic strength Yield strength Brinell hardness number Toughness Elastic strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a spring is cut down into two springs, the stiffness of cut springs will be None of these Double Same Half None of these Double Same Half ANSWER DOWNLOAD EXAMIANS APP
Machine Design For crank shaft bearings, the ratio of the length of the journal to its diameter is_________. Less than unity Equal to 1 None of these Greater than unity Less than unity Equal to 1 None of these Greater than unity ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS