Measurement and Instrumentation The adjustment of position of shading bands, in an energy meter is done to provide Friction compensation None of the listed here Breaking torque Creep compensation Friction compensation None of the listed here Breaking torque Creep compensation ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation To measure 5 volts, if one selects a 0-100 volt range voltmeter which is accurate with in ± 1%, then the error in this measurement may be up to ± 20% ± 7.5 % ± 2.5% ± 1.5% ± 20% ± 7.5 % ± 2.5% ± 1.5% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation ______ instruments are most sensitive. Dynamometer Moving iron Permanent magnet moving coil Hot wire Dynamometer Moving iron Permanent magnet moving coil Hot wire ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation PMMC type instruments normally use Fluid friction damping Eddy current damping Air friction damping None of these Fluid friction damping Eddy current damping Air friction damping None of these ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A 10MHz CRO has 10MHz vertical oscillator 10MHz supply frequency 10MHz horizontal oscillator 5MHz sweep 10MHz vertical oscillator 10MHz supply frequency 10MHz horizontal oscillator 5MHz sweep ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The time/div and voltage axes of an oscilloscope have been creased. A student connects a 1 KHz, 5 V P-P square wave calibrition pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (P-P) and period of the unknown signal are respectively 7.5 V, 2 ms. 5 V, 1 ms. 5 V, 2 ms. 10 V, 1 ms. 7.5 V, 2 ms. 5 V, 1 ms. 5 V, 2 ms. 10 V, 1 ms. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS