Engineering Drawing Some common blocks used by architectural drafters include __________. Appliances Door swings All of these Ceiling fans Appliances Door swings All of these Ceiling fans ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The first step in creating a traditional technical drawing is to ________. Set up the meter line Align the paper so that it will be positioned square to the parallel bar Sharpen the leads in the technical pens Draw a series of guide lines Set up the meter line Align the paper so that it will be positioned square to the parallel bar Sharpen the leads in the technical pens Draw a series of guide lines ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________. 3/4" = 1'-0" 1/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 3/4" = 1'-0" 1/4" = 1'-0" 1" = 100' 1/8" = 1'-0" ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first. Enter 3 for the length of the line Read the coordinate position on the Dynamic Readout Insure that Ortho is on Pull the line from away from the starting point very carefully Enter 3 for the length of the line Read the coordinate position on the Dynamic Readout Insure that Ortho is on Pull the line from away from the starting point very carefully ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In this type of section, one quarter of the object is removed: Removed section Half section Revolved section Quarter section Removed section Half section Revolved section Quarter section ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When drawing a line using the relative coordinate system a line is created from ________. 0, 0 None of these The beginning point of the last line The ending point of the last line 0, 0 None of these The beginning point of the last line The ending point of the last line ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS