Manufacturing And Production Technology Misrun is a casting defect which occurs due to Absorption of gases by the liquid metal Improper alignment of the mould flasks Very high pouring temperature of the metal Insufficient fluidity of the molten metal Absorption of gases by the liquid metal Improper alignment of the mould flasks Very high pouring temperature of the metal Insufficient fluidity of the molten metal ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Calculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. 600 welds/min, 1500 mm/min 500 welds/min, 1250 mm/min 22 welds/min, 55 mm/min 3000 welds/min, 75 mm/min 600 welds/min, 1500 mm/min 500 welds/min, 1250 mm/min 22 welds/min, 55 mm/min 3000 welds/min, 75 mm/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is ___ cutting speed for drilling mild steel with high speed steel drills. None of the listed here Less than Equal to More than None of the listed here Less than Equal to More than ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A fixture is defined as a device which Is used to check the accuracy of workpiece All of these Holds and locates a workpiece and guides and controls one or more cutting tools Holds and locates a workpiece during an inspection or for a manufacturing operation Is used to check the accuracy of workpiece All of these Holds and locates a workpiece and guides and controls one or more cutting tools Holds and locates a workpiece during an inspection or for a manufacturing operation ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The rake angle of a single point cutting tool corresponds to ___ of a twist drill. Point angle Chisel edge angle Lip clearance angle Helix angle Point angle Chisel edge angle Lip clearance angle Helix angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The top and sides of the table of a shaper usually have L-type slots I-type slots T-type slots Any one of these L-type slots I-type slots T-type slots Any one of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS