Manufacturing And Production Technology Lathe bed is made of Alloy steel Mild steel Chilled cast iron Pig iron Alloy steel Mild steel Chilled cast iron Pig iron ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A dynamo-meter is a device used for the measurement of Deflection of the cutting tool Chip thickness ratio Wear of the cutting tool Forces during metal cutting Deflection of the cutting tool Chip thickness ratio Wear of the cutting tool Forces during metal cutting ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The hole to be drilled for tapping is _________ the outside diameter of the thread on the tap. Smaller than Greater than Equal to None of the listed here Smaller than Greater than Equal to None of the listed here ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The carbide tools operating at very low cutting speeds (below 30 m/min) Reduces tool life Have no effect on tool life Spoils the work piece Increases tool life Reduces tool life Have no effect on tool life Spoils the work piece Increases tool life ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an interchangeable assembly, shafts of size 25.000 -0.0100⁺⁰∙⁰⁴⁰ mm mate with holes of size 25.000 -0.010⁺⁰∙⁰²⁰ mm. The maximum possible clearance in the assembly will be 10 microns 20 microns 30 microns 60 microns 10 microns 20 microns 30 microns 60 microns ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS