Design of Steel Structure In the cross-section of a weld, throat is the maximum dimension average dimension None of these minimum dimension maximum dimension average dimension None of these minimum dimension ANSWER DOWNLOAD EXAMIANS APP
Design of Steel Structure If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as 0 0.5 between 0.5 and 1.0 1.0 0 0.5 between 0.5 and 1.0 1.0 ANSWER DOWNLOAD EXAMIANS APP
Design of Steel Structure The slenderness ratio of lacing bars should not exceed 180 100 145 120 180 100 145 120 ANSWER DOWNLOAD EXAMIANS APP
Design of Steel Structure When the bolts are subjected to reversal of stresses, the most suitable type of bolt is black bolt high strength bolt ordinary unfinished bolt turned and fitted bolt black bolt high strength bolt ordinary unfinished bolt turned and fitted bolt ANSWER DOWNLOAD EXAMIANS APP
Design of Steel Structure Bearing stiffeners are provided ati) the supportsii) the mid spaniii) the point of application of concentrated loads The correct answer is both (i) and (ii) only (i) (i), (ii) and (iii) both (i) and (iii) both (i) and (ii) only (i) (i), (ii) and (iii) both (i) and (iii) ANSWER DOWNLOAD EXAMIANS APP
Design of Steel Structure The allowable tensile stress in structural mild steel plates for steel tank is assumed as 95.0 MPa on net area 150.0 MPa on gross area 105.5 MPa on gross area 105.5 MPa on net area 95.0 MPa on net area 150.0 MPa on gross area 105.5 MPa on gross area 105.5 MPa on net area ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS