Workshop Technology In average work, the tolerance produced by investment casting method is +0.2 mm ±0.05 mm +1 mm +05 mm +0.2 mm ±0.05 mm +1 mm +05 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The hot working of metals is carried out Below the recrystallisation temperature At any temperature At the recrystallisation temperature Above the recrystallisation temperature Below the recrystallisation temperature At any temperature At the recrystallisation temperature Above the recrystallisation temperature ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Tandem drawing of wires and tubes is necessary because Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For gas welding, the pressure desired at the welding torch for oxygen is 560 to 840 kN/m² 70 to 280 kN/m² 280 to 560 kN/m² 7 to 103 kN/m² 560 to 840 kN/m² 70 to 280 kN/m² 280 to 560 kN/m² 7 to 103 kN/m² ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In a four high rolling mill, the diameter of backing up rolls is ________ the diameter of working rolls. Larger than Equal to Smaller than None of these Larger than Equal to Smaller than None of these ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The maximum flame temperature occurs At the torch tip Between the outer and inner cone At the outer cone At the inner cone At the torch tip Between the outer and inner cone At the outer cone At the inner cone ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS