Chemical Engineering Basics In a casting, cold shut defect is caused by Melt-mould reactions Low pounhg temperature Very low mould permeability Faulty gating system Melt-mould reactions Low pounhg temperature Very low mould permeability Faulty gating system ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Lead is poured into the joints between two __________ pipes. Steel Cast iron Concrete Plastic Steel Cast iron Concrete Plastic ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressure volume plot ? Temperature - pressure Temperature - entropy Enthalpy - entropy Enthalpy-pressure Temperature - pressure Temperature - entropy Enthalpy - entropy Enthalpy-pressure ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics For the same heat input & compression ratio, efficiency of Otto cycle is higher than that of diesel cycle, because in Otto cycle. Expansion & compression are isentropic Heat rejection is lower Combustion is at constant volume Maximum temperature is higher Expansion & compression are isentropic Heat rejection is lower Combustion is at constant volume Maximum temperature is higher ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics The main function of the deaerator used in the thermal power plant is to Remove non-condensable gases from condenser Throttle down the steam pressure Remove dissolved gases from feed-water Enhance feed water temperature Remove non-condensable gases from condenser Throttle down the steam pressure Remove dissolved gases from feed-water Enhance feed water temperature ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Transformation range for ferrous material is the temperature interval during which __________ is formed during its heating. Martensite Cementite Austenite Pearlite Martensite Cementite Austenite Pearlite ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS