Engineering Drawing If a designer is developing a plan for a project in which the entire part is made out of ¾" thick plywood and he only wants to use one view, he should use the ________ view. Top Back Front Right Top Back Front Right ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________. Use Union to join them Use the Add Parts tool None of these Use the Join command Use Union to join them Use the Add Parts tool None of these Use the Join command ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing? Use the Tolerance tool to clean up the extension lines Use the Break tool to clean up the extension lines Use the stretch tool to clean up the extension lines Use the Modify tool to clean up the extension lines Use the Tolerance tool to clean up the extension lines Use the Break tool to clean up the extension lines Use the stretch tool to clean up the extension lines Use the Modify tool to clean up the extension lines ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing A round is a rounded surface on the ________ corner of a part. Outside Radial Inside Isoplane Outside Radial Inside Isoplane ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Which of the following is one of the basic types of welded joints: Groove joint Angle joint T-joint Rear joint Groove joint Angle joint T-joint Rear joint ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In a CAD system, you can draw an ellipse by specifying these: The center and major and minor axes The midpoint and end points The bounding lines The center and radius The center and major and minor axes The midpoint and end points The bounding lines The center and radius ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS