Workshop Technology For welding plates of thickness more than 12.5 mm, its edges Do not require bevelling Should have a double-V or U-groove on one side Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove Do not require bevelling Should have a double-V or U-groove on one side Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For gas welding, the pressure desired at the welding torch for acetylene is 7 to 103 kN/m² 280 to 560 kN/m² 560 to 840 kN/m² 70 to 280 kN/m² 7 to 103 kN/m² 280 to 560 kN/m² 560 to 840 kN/m² 70 to 280 kN/m² ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In forehand welding, the angle between the welding rod and the work is kept as 40°-50° 50°-60° 60°-70° 30°-40° 40°-50° 50°-60° 60°-70° 30°-40° ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology V-block is used to Check the trueness of flat surfaces Locate centres of round rods Check the surface roughness None of these Check the trueness of flat surfaces Locate centres of round rods Check the surface roughness None of these ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A basic shaft is one whose Lower deviation is zero None of the listed here Upper deviation is zero Lower and upper deviations are zero Lower deviation is zero None of the listed here Upper deviation is zero Lower and upper deviations are zero ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The mode of deformation of the metal during spinning is Stretching Bending and stretching Bending Rolling and stretching Stretching Bending and stretching Bending Rolling and stretching ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS