Manufacturing And Production Technology Flank wear depends upon the All of these Hardness of the work and tool material at the operating temperature Amount and distribution of hard constituents in the work material Degree of strain hardening in the chip All of these Hardness of the work and tool material at the operating temperature Amount and distribution of hard constituents in the work material Degree of strain hardening in the chip ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Greater than the lower limit of the hole Lesser than the upper limit of the hole Lesser than the lower limit of the hole Greater than the upper limit of the hole Greater than the lower limit of the hole Lesser than the upper limit of the hole Lesser than the lower limit of the hole Greater than the upper limit of the hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A CNC vertical milling machine has to cut a straight slot of 10 mm width and 2 mm depth by a cutter of 10 mm diameter between points (0,0) and (100,100) on the XY plane (dimensions in mm). The feed rate used for milling is 50 mm/min, milling time for the slot (in seconds) is 180 120 170 240 180 120 170 240 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For generating a Coon’s surface we require Two bounding curves and a set of grid control points A set of grid points on the surface A set of grid control points Four bounding curves defining the surface Two bounding curves and a set of grid control points A set of grid points on the surface A set of grid control points Four bounding curves defining the surface ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In drilling brass, a drill with Any helix angle can be used Zero helix angle is used High helix angle is used Low helix angle is used Any helix angle can be used Zero helix angle is used High helix angle is used Low helix angle is used ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The percentage of carbon in gray cast iron is in the range of 8 to 10 percent 1.25 to 1.75 percent 0.25 to 0.75 percent 3 to 4 percent 8 to 10 percent 1.25 to 1.75 percent 0.25 to 0.75 percent 3 to 4 percent ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS