Chemical Engineering Basics Brinell Hardness Number (BHN) for talc is approximately in the range of 1-5 200-250 20-30 100-150 1-5 200-250 20-30 100-150 ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Powder metallurgy process does not make metal powder by Grinding/milling Atomisation Hammering Electrolytic deposition Grinding/milling Atomisation Hammering Electrolytic deposition ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type Parallel flow with equal heat capacities Counter flow with equal heat capacities Counter flow with unequal heat capacities Parallel flow with unequal heat capacities Parallel flow with equal heat capacities Counter flow with equal heat capacities Counter flow with unequal heat capacities Parallel flow with unequal heat capacities ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics On increasing the yield strength of a steel from 450 to 650 MPa, its __________ will increase. Modulus of toughness Percent elongation Ultimate tensile strength (UTS) Modulus of resilience Modulus of toughness Percent elongation Ultimate tensile strength (UTS) Modulus of resilience ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Area under the stress-strain curve upto the __________ is referred to as the modulus of resilience. Elastic limit Yield strength Maximum point Proportional limit Elastic limit Yield strength Maximum point Proportional limit ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) T 1/T² 1/T T² T 1/T² 1/T T² ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS