Measurement and Instrumentation A moving iron ammeter produces a full scale torque of 240 μNm with a deflection of 120° at a current of 10 A. The rate of change of self induction (μH/radian) of the instrument at full scale is 2.0 μH/radian. 4.8 μH/radian. 114.6 μH/radian. 12.0 μH/radian. 2.0 μH/radian. 4.8 μH/radian. 114.6 μH/radian. 12.0 μH/radian. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Unit of deflection sensitivity of a CRO is mm / V. mm per mV. V / mm. meter / volt. mm / V. mm per mV. V / mm. meter / volt. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Piezoelectronic accelerometer Should be used for high frequencies above 100 Hz. Should be used for low frequency. Should use a monitoring source at low input impedance. Has a low natural frequency. Should be used for high frequencies above 100 Hz. Should be used for low frequency. Should use a monitoring source at low input impedance. Has a low natural frequency. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A 8085 microprocessor consist of Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and Memory. Arithmetic and Logic Units (ALU), Control Unit (CU) and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU) and Registers. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and Memory. Arithmetic and Logic Units (ALU), Control Unit (CU) and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU) and Registers. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read - 795 W. + 597 W. - 597 W. + 795 W. - 795 W. + 597 W. - 597 W. + 795 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A galvanometer with a full scale current of 10 mA has a resistance of 1000 Ω. The multiplying power (the ratio of measured current to galvanometer current) of 100 Ω shunt with this galvanometer is 10. 110. 11. 100. 10. 110. 11. 100. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS