Analog Electronics A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ. At the frequency of 4KHZ,the o/p voltage will be 1.4v 1v 2v 2.8v 1.4v 1v 2v 2.8v ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Silicon and Germanium are ________ elements. tetravalant pentavalant trivalant hexavalant tetravalant pentavalant trivalant hexavalant ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The negative part of the output signal in a transistor circuit starts clipping if the Q point of the circuit moves toward the saturation point. toward the center of the load line. toward the cutoff point. None of these toward the saturation point. toward the center of the load line. toward the cutoff point. None of these ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics What is the most important fact about the collector current? It is measured in milliampere. It is small. It approximately equals the emitter current. It equals the base current divided by the current gain. It is measured in milliampere. It is small. It approximately equals the emitter current. It equals the base current divided by the current gain. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which of following is the point of reference JFET? Gate. Source. None of above. Drain. Gate. Source. None of above. Drain. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics If the base resistor is very small, the transistor will operate in the cutoff region. saturation region. All of these active region. cutoff region. saturation region. All of these active region. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS