Measurement and Instrumentation A 8085 microprocessor consist of Arithmetic and Logic Units (ALU), Control Unit (CU) and Registers. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and Memory. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU) and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU) and Registers. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and Memory. Arithmetic and Logic Units (ALU), Control Unit (CU), Registers and I/O devices. Arithmetic and Logic Units (ALU), Control Unit (CU) and I/O devices. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Which wave has the least form factor? Triangular wave Sine wave Square wave Rectangular wave Triangular wave Sine wave Square wave Rectangular wave ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation If two 300V full scale voltmeters V1 and V2 having sensitivities of 100 kOhm/V and 150 kOhm/V are connected in series to measure 500V then V1 = 300V and V2 = 200V. V1 = 200V and V2 = 300V. V1 = 0V and V2 = 0V. V1 = 250V and V2 = 250V. V1 = 300V and V2 = 200V. V1 = 200V and V2 = 300V. V1 = 0V and V2 = 0V. V1 = 250V and V2 = 250V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Potentiometer method of DC voltage measurement is more accurate than direct measurement using a voltmeter because It does not load the circuit at all. It loads the circuit moderately. It loads the circuit to maximum extent. It uses centre zero galvanometer instead of voltmeter. It does not load the circuit at all. It loads the circuit moderately. It loads the circuit to maximum extent. It uses centre zero galvanometer instead of voltmeter. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The given figure shows wein bridge connection for frequency measurement. C and R are variables and gang together. For balanced condition the expression for frequency is f = 1/2πCR when R1 = 3R2. R1 = 2R2. R1 = R2/2. R1 = R2. R1 = 3R2. R1 = 2R2. R1 = R2/2. R1 = R2. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The maximum percentage error in the sum of two voltage measurements when V1 = 100V ± 1% and V2 = 80V ± 5% is ± 4% ± 6% ± 2.8% ± 3% ± 4% ± 6% ± 2.8% ± 3% ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS