Manufacturing And Production Technology A 15 mm drilling machine means that it can drill a hole None of these Of maximum diameter 15 mm In 15 mm thick plates None of these Of maximum diameter 15 mm In 15 mm thick plates ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Lesser than the lower limit of the hole Greater than the lower limit of the hole Lesser than the upper limit of the hole Greater than the upper limit of the hole Lesser than the lower limit of the hole Greater than the lower limit of the hole Lesser than the upper limit of the hole Greater than the upper limit of the hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 20.56 26.56 36.56 30.56 20.56 26.56 36.56 30.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A single point thread cutting tool should ideally have Negative rake angle Zero rake angle Point angle Positive rake angle Negative rake angle Zero rake angle Point angle Positive rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 8 10 7 9 8 10 7 9 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The trade name of a nonferrous cast alloy composed of cobalt, chromium and tungsten is called Stellite Cemented carbide Ceramic Diamond Stellite Cemented carbide Ceramic Diamond ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS